#Lepton flir sparkfun serial#
#Lepton flir sparkfun full#

The Lepton 2.5 can output a factory-calibrated temperature value for all 4800 pixels in a frame irrespective of the camera temperature with an accuracy of +/-5☌. The Radiometric Lepton® LWIR module included in each Dev Kit acts as a sort of camera and packs a resolution of 80 × 60 active pixels into a camera body that is smaller than a dime and captures infrared radiation input in its nominal response wavelength band (from 8 to 14 microns) and outputs a uniform thermal image.

#Lepton flir sparkfun full#

All you need to do to get this kit set up, simply attach the Lepton® imager module into the provided breakout, connect the headers, and you will be seeing in full darkness in no time! This kit includes a breakout as well as the Lepton® 2.5 longwave infrared (LWIR) imager.

#Lepton flir sparkfun serial#

Dual Low Noise LDO for 2.PiicoDev OLED Display Module (128圆4) SSD1306 Price: $13.10ġ0k Slide Potentiometer - (Long Shaft) Price: $6.55ġ6 Mb Serial Flash Memory (16Mb, QSPI, W25Q16JVSSIQ) Price: $2.70ĭo you see what Sparkfun see? With the FLIR Radiometric Lepton® Dev Kit v2 you will be able to bring FLIR's thermal imaging reliability and power to your Arduino, Raspberry Pi, or any ARM based development tool all in an easy to access breadboard friendly package.

Power Efficient 1.2V core voltage (can be by-passed).

25-MHz reference clock (can be by-passed).

Low operating power, nominally 150 mW (Output Format: User-selectable 14-bit, 8-bit (AGC applied), or 24-bit RGB (AGC and colorization applied).

Radiometric accuracy (35☌ Blackbody) Greater of:.

1x FLIR Lepton® 2.5 - Thermal Imaging Module.

When inserting it into the breakout board be sure to use proper personal grounding, such as a grounding wrist strap, to prevent damage the module. The Radiometric Lepton module is extremely sensitive to electrostatic discharge (ESD). Note: This kit comes in two separate parts and will need to be assembled once received. A few things to consider about this kit: the breakout board will accept a 3-5.5V input and regulate it to what the Lepton® wants, to read an image from the lepton module all you need is an SPI port, and to configure the camera settings you also need an I 2C port, although this is not required. Meanwhile, each breakout board in these kits provides the socket for the Lepton, on-board power supplies, 25Mhz reference clock (can be by-passed), power efficient 1.2v core voltage (can be by-passed), dual low noise LDO for 2.8V voltage (can be by-passed), 100 mil header for use in a breadboard or wiring to any host system. The Lepton 2.5 can output a factory-calibrated temperature value for all 4800 pixels in a frame irrespective of the camera temperature with an accuracy of +/-5˚C.

Do you see what we see? With the FLIR Radiometric Lepton® Dev Kit v2 you will be able to bring FLIR's thermal imaging reliability and power to your Arduino, Raspberry Pi, or any ARM based development tool all in an easy to access breadboard friendly package.